Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

- Introduction
   About this Management
   Mazda-323 brand cars — the introduction
   Identification numbers of the car
   Acquisition of spare parts
   Technology of service, tools and equipment of a workplace
   Start of the engine from an auxiliary source
   Poddomkrachivaniye and towage
   Automobile chemicals, oils and lubricants
   Diagnostics of malfunctions
   Routine maintenance
   + Works on maintenance
   - Box transfers/drive of wheels
      Visual check of tightness
      Mechanical transmission: Check of level of oil
      Mechanical transmission: Oil replacement
      Automatic transmission: Check of level of oil
      Box of differential and transfer case: Check of level of oil
      Box of differential and transfer case: Oil replacement
      Check of rubber cuffs of power shafts
      Check of level of liquid of the drive of coupling
      Check/adjustment of a pedal of coupling
   + Brakes/tires/wheels
   + Steering management / drive of forward wheels
   + Car electric equipment
   + Body / internal equipment
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits






Automatic transmission: Check of level of oil

The following spare parts are necessary:

  • ATF Dexron - II or M - III

Check

 PERFORMANCE ORDER

  1. To warm up the engine a trip on 20 km, then the transmission will have temperature of oil of at least +65 °C.
  2. To install the car on a plain surface.
  3. To allow the engine 2 minutes to work idling. To tighten the emergency brake to switch the lever of the choice of transfer to all provisions and to leave in situation P.
  1. To take out a measuring core and to wipe a pure rag.
  1. To insert a core back and to take out again.
  2. To check oil level. If necessary slowly to add oil by means of a funnel and a grid.

Level of oil should not be below the minimum marks, otherwise it can lead to damages of the transmission. If the level of oil is above the maximum marks (F), it can lead to a box overheat that will cause leakage. If level is too high, oil should be pumped out.

If oil of the automatic transmission has black color and a smell of burning, so the transmission is faulty and has to be checked in a workshop.