Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

- Introduction
   About this Management
   Mazda-323 brand cars — the introduction
   Identification numbers of the car
   Acquisition of spare parts
   Technology of service, tools and equipment of a workplace
   Start of the engine from an auxiliary source
   Poddomkrachivaniye and towage
   Automobile chemicals, oils and lubricants
   Diagnostics of malfunctions
   Routine maintenance
   + Works on maintenance
   + Box transfers/drive of wheels
   - Brakes/tires/wheels
      Check of level of brake fluid
      Check of thickness of brake shoes
      Check of the parking brake
      Replacement of brake fluid
      Check of pressure in tires
      Check of a protector
      Check of a zolotnik of the tire
   + Steering management / drive of forward wheels
   + Car electric equipment
   + Body / internal equipment
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits






Replacement of brake fluid

Necessary special tool:

  • Cap key for pumping gates. Necessary spare details:
  • Brake fluid of the SAE J 1703, DOT 3 specification.

Brake fluid through a time in hoses and through an air vent of a compensation tank absorbs moisture from air. Because of it the boiling point of brake fluid in use goes down. At strong impact on brakes it can lead to formation of steam traffic jams in brake pipelines because of what efficiency of braking strongly decreases.

Brake fluid has to be replaced each 2 years, whenever possible in the spring. At frequent trips in mountains brake fluid should be replaced more often.

To follow rules of the treatment of brake fluid, see the Head the Brake system.

 PERFORMANCE ORDER

  1. To pump out by means of a suction brake fluid from a broad tank to the level of 10 mm.

Not to devastate a compensation tank completely that air did not get to the brake system.

  1. To fill a compensation tank with new brake fluid to the mark "Move".

To open pumping gates on wheel cylinders and supports carefully not to overwind them. It is recommended, to cover gates in 2 hours before pumping by rust solvent. At strongly sitting gates to make pumping in a workshop.


  1. To attach a pure hose to the pumping gate on the right back support, to substitute a suitable vessel.
  1. To ask the assistant to pump over several times a brake pedal, pressure will not be created yet, to hold a pedal of a brake pressed, to open the pumping gate. Holding a leg on a pedal, to close the gate. To remove a leg from a pedal. To repeat this procedure on each gate to тез a time, only new brake fluid will not begin to act yet.
  2. To close the pumping gate, to fill a compensation tank with new brake fluid.
  3. In the same way to extort old brake fluid from other supports or cylinders in the sequence — back right, back left, forward right, forward left.

The following brake fluid has to be transparent and not have bubbles.

  1. Old brake fluid should be handed over in special point.