Mazda 323

since 1985 release

Repair and operation of the car

Mazda 323

- Introduction
   About this Management
   Mazda-323 brand cars — the introduction
   Identification numbers of the car
   Acquisition of spare parts
   Technology of service, tools and equipment of a workplace
   Start of the engine from an auxiliary source
   Poddomkrachivaniye and towage
   Automobile chemicals, oils and lubricants
   Diagnostics of malfunctions
   Routine maintenance
   + Works on maintenance
   + Box transfers/drive of wheels
   + Brakes/tires/wheels
   + Steering management / drive of forward wheels
   + Car electric equipment
   - Body / internal equipment
      Visual check of a bottom/body
      Lubricant of locks
      Visual check of all seat belts
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits

Visual check of all seat belts

Noise at a pulling of a belt is caused functionally. At unusual noise the seat belt can only be replaced. Oil or lubricant should not be applied to elimination of noise at all. Automatic equipment should not understand as at the same time the compressed spring can jump out. Danger of accident.


  1. To completely extend a seat belt and to check for existence of break of fibers. Damages can arise because of jamming of a belt or the burning cigarette. In this case the belt should be replaced.
  2. In the presence of shabby places, and fibers are not broken off, the seat belt is not required to be replaced.
  3. To check a belt with the heavy course whether it is overwound, if necessary to remove a casing on an average rack of a body.
  4. If automatic equipment of a belt does not work, the belt should be replaced.
  5. To clear belts only soap and water, not to apply solvents or chemical cleaners at all.