Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and system of steering
   Forward suspension bracket — the general information
   Removal and installation of a depreciation rack
   Dismantling of a depreciation rack / removal and installation of the shock-absorber / screw spring
   Check of the shock-absorber
   Removal and installation of the cross lever / replacement of a rubber support
   Check/replacement of a support of the cross lever / rotary fist
   Removal and installation of a power shaft
   Removal and installation of an intermediate shaft
   Check/dismantling of a driving shaft / replacement of cuffs
   Bearing of a forward nave
   Back suspension bracket
   Removal and installation of a back depreciation rack
   Dismantling of a back depreciation rack / removal and installation of the shock-absorber / screw spring
   Cross levers / longitudinal lever / stabilizer
   Check of the hug bearing
   Removal and installation of the hug bearing
   Adjustment of a side play of the hug bearing
   Removal and installation of a nave
   Steering
   Removal and installation of a steering wheel
   Removal and installation of a tip of steering draft
   Removal and installation of a rubber cuff of the steering drive
   Servoupravleniye pump
   Angles of installation of wheels
   Values for check of MAZDA 323
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits











Removal and installation of a steering wheel

Removal

 PERFORMANCE ORDER

  1. To establish wheels in average situation.
  2. To disconnect a weight cable from the battery.

At the same time data from memory of malfunctions of the engine or a protective code of the radio receiver are erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal also installation of the battery.


  1. To unscrew slip bolts (a key of a sound signal) on a reverse side of a steering wheel. To remove a slip.
  1. To turn out bolts of a steering wheel by means of a face nozzle with the extender.
  1. To remove a steering wheel a suitable stripper from a steering shaft.

Not to strike to a steering column blows with the hammer as it because of it will develop.

Installation

 PERFORMANCE ORDER

  1. To check that the lever of indexes of turn was on average situation, otherwise at installation of a steering wheel the cam can be damaged.
  2. To put on a steering wheel shlitsevy connection of a shaft so that spokes settled down horizontally.
  3. To tighten a bolt of a steering wheel with effort of 40 Nanometers.
  4. To connect a cable of mass of the battery, to check work of a sound signal.
  5. To make a trial trip and at the movement on a straight line to check installation of a steering wheel. Spokes of a steering wheel have to settle down horizontally, otherwise respectively rearrange a wheel.
  6. To check automatic equipment of return of the lever of indexes of turn.
  7. If are available, to determine time on hours and to set a protective code of the radio receiver.