Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and system of steering
   Forward suspension bracket — the general information
   Removal and installation of a depreciation rack
   Dismantling of a depreciation rack / removal and installation of the shock-absorber / screw spring
   Check of the shock-absorber
   Removal and installation of the cross lever / replacement of a rubber support
   Check/replacement of a support of the cross lever / rotary fist
   Removal and installation of a power shaft
   Removal and installation of an intermediate shaft
   Check/dismantling of a driving shaft / replacement of cuffs
   Bearing of a forward nave
   Back suspension bracket
   Removal and installation of a back depreciation rack
   Dismantling of a back depreciation rack / removal and installation of the shock-absorber / screw spring
   Cross levers / longitudinal lever / stabilizer
   Check of the hug bearing
   Removal and installation of the hug bearing
   Adjustment of a side play of the hug bearing
   Removal and installation of a nave
   Steering
   Removal and installation of a steering wheel
   Removal and installation of a tip of steering draft
   Removal and installation of a rubber cuff of the steering drive
   Servoupravleniye pump
   Angles of installation of wheels
   Values for check of MAZDA 323
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits






Removal and installation of a tip of steering draft

Removal

 PERFORMANCE ORDER

  1. To weaken nuts of a wheel of the car standing on the earth.
  2. To change the provision of a disk of a wheel concerning a nave that the balanced wheel could be established in former situation.
  3. To lift a forward part of the car.
  4. To remove a wheel.
  1. To unscrew a tip of steering draft - And - from the lever of a rotary fist - F-, for this purpose to take out the forelock - E-and to turn off a lock-nut - D-, - In - a lock-nut, - With - steering draft.
  1. To Vypressovat a tip of steering draft - And - a standard stripper - With-. - In - the lever of a rotary fist.
  1. To weaken a lock-nut and to unscrew a tip from steering draft.

To mark speed to screw the hinge at installation in the same situation.

Installation

 PERFORMANCE ORDER

  1. To screw a tip of steering draft on the written-down speed, not to tighten a lock-nut yet.
  2. To insert the hinge into the lever of a rotary fist.
  3. To tighten a lock-nut with effort of 50 Nanometers and to fix by the new forelock. If the forelock is not inserted into an opening, a nut not to weaken, and to tighten further until the forelock rises into place.
  4. To screw a wheel, considering a tag on a nave. To lower the car and to tighten wheel nuts cross-wise with effort of 100 Nanometers.
  5. To rock a little the car that suspension bracket elements sat down.
  6. To check adjustment of a convergence (it is carried out in a workshop) and to tighten a lock-nut on a tip of steering draft with effort of 40 Nanometers.