Repair and operation of the car Mazda 323 - Check of thickness / side beating of a brake disk//m323.ru

Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
- Brake system
   Specifications of the brake system
   Forward brake
   Removal and installation of front brake shoes
   Check of thickness / side beating of a brake disk
   Removal and installation of blocks of a back disk brake
   Removal and installation of a support of a brake
   Removal and installation of a brake disk
   Removal and installation of back brake blocks / brake drum
   Removal and installation of the wheel brake cylinder
   Repair of the wheel brake cylinder
   Brake fluid
   Pumping of the brake system
   Replacement of brake pipelines and hoses
   Check of the brake amplifier
   Removal and installation of the switch of stoplights
   Emergency brake
   Adjustment of the emergency brake
   Anti-blocking system (ABS)
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits






Check of thickness / side beating of a brake disk

 PERFORMANCE ORDER

  1. Processing of brake disks is not allowed. In the presence of grooves 0,5 mm are deeper or strong wear the disk has to be replaced. At the same time always to replace both disks on one axis.
  2. To mark the provision of a disk of a wheel concerning a nave that the balanced wheel could be established in former situation.
  3. To weaken nuts of a wheel of the car standing on the earth.
  4. To lift a forward part of the car.
  5. To remove a wheel.
  6. Cars from 10/89 g of the issue, except models "the versatile person: To screw 2 nuts of a wheel that the brake disk was correctly отцентрован.
  1. To measure thickness of a brake disk. In workshops the special measuring instrument or a micrometer as because of wear on a brake disk the edge is formed is for this purpose used. Thickness of a disk can also be measured by a usual caliper, however from each party of a disk it is necessary to enclose laying of the known thickness. For determination of exact thickness of a disk it is necessary to subtract the total thickness of laying from the received value.

To perform measurement in several points of a disk.

  1. If the limit of wear is reached, the brake disk should be replaced. Limit of wear see the Section Specifications of the brake system
  2. In the presence of big cracks and grooves 0,5 mm are deeper, the brake disk should be replaced.
  1. If there is an arrow indicator, to measure a side beating of a brake disk in the established state. To install the indicator to an outer edge. The required value: maximum side beating of 0,1 mm. Too big side beating can be caused by the broken hug bearing, for check to address in a workshop.
  1. If necessary to unscrew wheel nuts.
  2. To screw a wheel, considering a tag on a nave. To lower the car and to tighten wheel nuts cross-wise with effort of 100 Nanometers.