Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
- Wheels and tires, body, coloring of the car, care of the car
   The sizes of disks and tires/pressure in tires
   Designations of disks
   Designations of tires
   Replacement of wheels
   Rules of care of tires
   Balancing of wheels
   Antisliding chains
   Spare wheel
   Wear of tires
   Body
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal and installation of a front grille
   Removal and installation of side moldings
   Removal and installation of a forward wing
   Removal and installation/adjustment of a cowl
   Removal and installation/adjustment of a door of a back
   Removal and installation/adjustment of a door
   Upholstery door door/window regulator/glass
   Removal and installation of an upholstery of a door
   Removal and installation of a glass/window regulator of a forward door
   Door lock lock/handle/cylinder
   Back door lock / internal drive
   External mirror
   Removal and installation of glass of a mirror
   Panel of devices / average console
   Front seats
   Removal and installation of a back seat
   Back seat
   Coloring of the car
   Elimination of damages from stones
   Rikhtovka body/repair of rusty openings
   Preparation for painting
   Coloring
   Wash of the car
   Care of a varnish covering
   Protection of the bottom and preservation of cavities
   Care of an upholstery
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits











Rules of care of tires

Tires have so-called "memory" and the negligent treatment of them — for example, bystry or frequent moving through obstacles — leads to their premature failure.

 Cleaning of tires

Whenever possible not to clear the tire the steam-ejecting device. If the nozzle of the steam-ejecting device is brought too close, the rubber layer will be destroyed for a short time, also at use of cold water. The tire cleared thus has to be replaced for the purpose of safety.

Also such tires which had long contact with oil or lubricant have to be replaced. The tire is pressed through in these parts, however then takes the former form and outside looks intact. However tire loading capacity strongly decreases.

 Storage of tires

Tires have to be stored in the cool, dark and dry place. They should not contact to oil or lubricant.

It is necessary to store wheels in lying either hover in a garage or the cellar.

Before removing wheels it is necessary to increase pressure in tires (approximately by 0,3 - 0,5 Bars).

For winter tires to use the disks, so reassembling of tires on the same disks is not expedient for cost reasons.

Running in of tires

New tires have very smooth surface. Therefore new tires - it belongs as well to a spare wheel - have to be rolled. At a running in the surface of tires becomes because of wear of rougher. On the first 300 km with new tires it is necessary to go very carefully, especially by the crude road.