Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
- System of electric equipment
   Search of malfunctions of electric system
   Check of the switch on a current transmission
   Check of the relay
   Check of the motor of a screen wiper
   Verification of indexes of turn
   Check of stoplights
   Check of a heater of back glass
   Separation and connection of cable plugs
   Arrangement of safety locks
   Replacement of safety locks
   Removal and installation of the battery
   Check of the battery
   The battery is discharged in itself
   Battery charging
   Storage of the battery
   Generator
   Security measures for the generator of alternating current
   Check of tension of the generator
   Removal and installation of the generator
   Generator components
   Dismantling generator/replacement of coal brushes
   Removal and installation of a starter
   Check/replacement of the traction relay of a starter
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits






Check of tension of the generator

 PERFORMANCE ORDER

  1. To connect the voltmeter between plus and minus poles of the battery.
  2. To start the engine. At start tension should not fall lower than 8 V (at an external temperature of +20 °C).
  3. To increase speed to 2000 rpm. Tension has to make 14,1 - 14,7 V. Eto points that the generator and the regulator work. Tension of the generator has to be higher than the battery tension that the battery was recharged at the movement.
  4. To check stability of adjustment. For this purpose to turn on driving beam and to repeat measurement at 2000 rpm. The measured tension should not be more than is 0,4 B higher than earlier measured value.
  5. If the measured values lie out of admissible limits, to check the generator in a workshop.