Mazda 323

since 1985 release

Repair and operation of the car

Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
- System of electric equipment
   Search of malfunctions of electric system
   Check of the switch on a current transmission
   Check of the relay
   Check of the motor of a screen wiper
   Verification of indexes of turn
   Check of stoplights
   Check of a heater of back glass
   Separation and connection of cable plugs
   Arrangement of safety locks
   Replacement of safety locks
   Removal and installation of the battery
   Check of the battery
   The battery is discharged in itself
   Battery charging
   Storage of the battery
   Security measures for the generator of alternating current
   Check of tension of the generator
   Removal and installation of the generator
   Generator components
   Dismantling generator/replacement of coal brushes
   Removal and installation of a starter
   Check/replacement of the traction relay of a starter
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits

Verification of indexes of turn

Steps for indexes of turn and the alarm system are developed by one relay, the so-called breaker of signals of turn.

If a blinking rhythm on one party quicker than on another, from the "bystry" party the lamp is faulty or there is a break of a wire.

At all other malfunctions most often the relay is the reason. For check of the relay to remove.

 From 10/89 g of the issue.


  1. To disconnect the relay and to check separate contacts for course of current. At the same time to set on an ohmmeter a measurement limit kilohms (kOhm). Between the following contacts current has to proceed or to be resistance:-e;-f; c-a; c-d; c-e; c-f; c-g; c-h; h-a; h-c; h-d; h-e; h-f; h - g.
  1. Between other contacts current should not proceed, or resistance has to be equal to infinity.

With 9/85 on 9/89 g of the issue.


  1. To connect through auxiliary cables plus batteries to the plug B, the mass of the battery to the plug E. Then between the L and E or E plugs and weight to connect in parallel 2 lamps of indexes of turn (21 W). Lamps have to blink in a normal rhythm, otherwise replace the relay.
  1. If there is no new relay, to carefully insert a thin wire into the relay plug between plugs B and L

At the same time sensitive contacts of the relay should not be damaged. Before installation to bend the ends of a wire that there were no keen edges. To install the faulty relay into place. Connection plugs so long that the relay will be inserted despite a crossing point.

  1. To include ignition. If now to turn on the lever of signals of turn, the corresponding lamp will light up, without blinking. Inclusion and switching off of the lever it is possible to set a rhythm. However: To install the new relay whenever possible quicker.
  2. If indexes of turn do not burn despite a crossing point of contacts, malfunction consists in the switch or electric wires.