Repair and operation of the car Mazda 323 - Separation and connection of cable plugs//m323.ru

Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
- System of electric equipment
   Search of malfunctions of electric system
   Check of the switch on a current transmission
   Check of the relay
   Check of the motor of a screen wiper
   Verification of indexes of turn
   Check of stoplights
   Check of a heater of back glass
   Separation and connection of cable plugs
   Arrangement of safety locks
   Replacement of safety locks
   Removal and installation of the battery
   Check of the battery
   The battery is discharged in itself
   Battery charging
   Storage of the battery
   Generator
   Security measures for the generator of alternating current
   Check of tension of the generator
   Removal and installation of the generator
   Generator components
   Dismantling generator/replacement of coal brushes
   Removal and installation of a starter
   Check/replacement of the traction relay of a starter
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits






Separation and connection of cable plugs

 PERFORMANCE ORDER

  1. For separation of cable connections on a box of safety locks or electric consumers it is necessary to pull not for a cable, and for the plug.

Plugs are equipped with various clamps. To press clamps in the places designated by shooters and at the same time to disconnect the plug.


  1. At connection to squeeze the socket, the clamp will not be latched yet.
  1. During the checking of course of current or voltage measurement test probes can be inserted only from a reverse side of the plug (from a cable). If probes are inserted into nests of the socket, nests are deformed that will lead to weakening of contact.

In case of waterproof sockets (in a motive compartment) probes should not be inserted from a cable. In this case to separate the socket. To watch that at insertion of the probe of the plug were not damaged.


  1. When replacing the plug in the plug to insert from the open party the narrow screw-driver between tightening uvulas and the plug. To wring out a uvula up and to take out the plug back. To insert the new plug until it is latched. To pull for a cable to be convinced that the plug is reliably fixed.