Mazda 323

since 1985 release

Repair and operation of the car

Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
- Heater, system of lighting, devices
   Fan motor
   Removal and installation of the fan of a heater
   Control unit of a heater
   Adjustment of drives of a heater
   Check of the motor of fans/preresistors
   Check of the switch of a heater
   System of lighting
   Table of lamps
   Replacement of lamps of external lighting
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of back lamps
   Instrument guard
   Removal and installation of an instrument guard
   Removal and installation of the radio receiver
   Removal and installation of loudspeakers
   Removal and installation of the shtyrevy antenna
   Replacement of brushes of screen wipers
   Removal and installation/adjustment snuffled windscreen washer
   Removal and installation of levers of a forward screen wiper
   Forward screen wiper
   Removal and installation of the motor of a forward screen wiper
   Back screen wiper
   Removal and installation of the motor of a back screen wiper
   Removal and installation of the lever of a back screen wiper
+ Governing bodies and methods of operation
+ Electric circuits

Replacement of brushes of screen wipers

Screen wiper elastic bands at an unsatisfactory state should be replaced. On sale there are as the completed brushes (elastic bands with holders), and separately elastic bands. If only the elastic band is replaced, to watch that the holder was not bent.



  1. To cast away the screen wiper lever up.
  1. To establish a brush at right angle to the lever.
  2. To press a polymeric lock bracket, to press a brush in the direction of an arrow and to take out from a lever hook.
  3. To remove a brush through an opening near a polymeric bracket from the lever.
  1. To take out an elastic band with brackets from metal fastening.
  1. To take out the metal holder from an elastic band and to insert into a new elastic band so that dredging of a level was turned to an elastic band and rubber ledges entered grooves.

Holders should not be bent at the same time, if necessary replace.



  1. To insert a new elastic band-21-with a level of fastening-22-into metal brackets of a brush. At the same time to begin with the open party of an elastic band.
  1. To insert a brush into the lever; a screen wiper and to allow to be latched to a polymeric lock bracket.
  2. To cast away the screen wiper lever into place. At the same time to watch that the elastic band adjoined to glass everywhere.