Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
- Heater, system of lighting, devices
   Heater
   Fan motor
   Removal and installation of the fan of a heater
   Control unit of a heater
   Adjustment of drives of a heater
   Check of the motor of fans/preresistors
   Check of the switch of a heater
   System of lighting
   Table of lamps
   Replacement of lamps of external lighting
   Headlight
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of back lamps
   Devices
   Instrument guard
   Removal and installation of an instrument guard
   Devices
   Removal and installation of the radio receiver
   Removal and installation of loudspeakers
   Removal and installation of the shtyrevy antenna
   Replacement of brushes of screen wipers
   Removal and installation/adjustment snuffled windscreen washer
   Removal and installation of levers of a forward screen wiper
   Forward screen wiper
   Removal and installation of the motor of a forward screen wiper
   Back screen wiper
   Removal and installation of the motor of a back screen wiper
   Removal and installation of the lever of a back screen wiper
+ Governing bodies and methods of operation
+ Electric circuits






Removal and installation of the motor of a forward screen wiper

Removal

 PERFORMANCE ORDER

  1. To disconnect a weight cable from the battery.

At the same time data from memory of malfunctions of the engine or a protective code of the radio receiver are erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal also installation of the battery.


  1. To disconnect the multicontact plug from the motor.
  1. To unscrew the motor from a body plate (2 bolts).
  2. To wring out draft-6-from a crank the-5-big screw-driver.

If it is required to remove a crank from the motor, previously it is necessary to mark its situation concerning the holder (tag).

Installation

 PERFORMANCE ORDER

  1. At installation of the new motor of its steklochistitel it is necessary to bring into final situation at first. For this purpose to connect the plug and to allow to work to the motor about 1 minute. Then to switch off the motor the switch and to allow to be established in final situation. To switch-off the plug.
  2. To screw a crank on the motor according to the put tag on the holder and to tighten 15 Nanometers with effort.
  3. To establish draft on a crank and to screw the motor by effort of 10 Nanometers.
  4. To connect the multicontact plug.
  5. To connect a weight cable to the battery.
  6. To check work of a screen wiper.
  7. If are available, to determine time on hours and to set a protective code of the radio receiver.