Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
- Heater, system of lighting, devices
   Heater
   Fan motor
   Removal and installation of the fan of a heater
   Control unit of a heater
   Adjustment of drives of a heater
   Check of the motor of fans/preresistors
   Check of the switch of a heater
   System of lighting
   Table of lamps
   Replacement of lamps of external lighting
   Headlight
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of back lamps
   Devices
   Instrument guard
   Removal and installation of an instrument guard
   Devices
   Removal and installation of the radio receiver
   Removal and installation of loudspeakers
   Removal and installation of the shtyrevy antenna
   Replacement of brushes of screen wipers
   Removal and installation/adjustment snuffled windscreen washer
   Removal and installation of levers of a forward screen wiper
   Forward screen wiper
   Removal and installation of the motor of a forward screen wiper
   Back screen wiper
   Removal and installation of the motor of a back screen wiper
   Removal and installation of the lever of a back screen wiper
+ Governing bodies and methods of operation
+ Electric circuits






Check of the motor of fans/preresistors

If the fan does not work only at one step, as a rule, the preresistor is faulty. In this case to replace all preresistors.

To remove a glove compartment, see the Head Kolesa and tires, a body, coloring of the car, care of the car, the Section Panel of Devices / Average the console.

Fan motor

 PERFORMANCE ORDER

  1. To disconnect the plug from the fan motor.
  1. Tax by means of auxiliary cables tension of the battery (12B) on plugs and +/plus) and b (-/minus).
  1. The motor has to start working, otherwise replace the motor.

Preresistors

 PERFORMANCE ORDER

  1. To disconnect the plug of a payment of resistors.
  1. To check for a current transmission the following plugs by means of an ohmmeter: and — b; and — with; and — d. If at least in one case absence course of current is revealed, preresistors should be replaced. Values of separate resistance lie ranging from 0,5 Ohms to 1,5 Ohms.