Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
- Governing bodies and methods of operation
   Before landing in the car
   Running in
   Keys
   Locks of doors
   The uniform (central) locking device (if is available)
   Protection against pranks of children (if is available, only on back doors)
   The power window (if is available)
   Back rotary glasses (on 3-door models)
   Seats
   Adjustment of height of a steering wheel (if is available)
   Seat belts (if is available)
   Door back/trunk lid
   Fuelling
   Mirrors
   Luggage belts
   Trunk lid (if is available)
   Spare wheel
   Dashboard
   - Steering wheel and gear shifting
      Lock of ignition and steering column
      Start of the engine
      Management of RKPP and transfer case
      Operation of the car with the automatic transmission
      Recommendations for economic operation
      Tempostat (switch of the mode of maintenance of constant speed)
      Lighting and light alarm system
      Screen wiper and windscreen washer
      Control panel
      Other devices and equipment
      Heater and ventilation
      The conditioner (if is available)
      Lamps of salon, luggage carrier and lamp for reading (if is available)
      The movable hatch (if is available)
      Start by pushing or towage
      Motive compartment
+ Electric circuits






The conditioner (if is available)

Operation of the conditioner

 PERFORMANCE ORDER

  1. Close side deflectors of fresh air.
  2. Install the lever of adjustment of temperature in a desirable position.
  3. Start the engine, press the switch of the conditioner and determine the desirable speed of the fan.
  4. Adjustment for the maximum power of cooling.
  5. Type A — Shift temperature lever completely to the left, install the lever of the fresh / circulating air in a position "" and install the fan speed switch in situation 4.
  6. Type B — Press a key of the fresh / circulating air, so that the indicator lit up, and install the fan speed switch in situation 4.

Conditioner switch

The conditioner joins and switched off by pressing of the switch.

Even if the conditioner is not used long time, it should be included for several minutes once a week to grease compressor details.

Type A

Type B

Instructions on operation of the conditioner

  • If the car was left under direct beams of the sun, before turning on of the conditioner open a window, so that heated air could come out.
  • At a rain it is possible to avoid fogging of glasses if to lower temperatures in salon by means of the conditioner.
  • At slow trains in a dense transport stream the power of the conditioner is limited because of idling of the engine.
  • In this case move on low transfer to improve conditioner power.
  • In due time you perform works on check and maintenance, so that it was ready to work at any time.