Mazda 323

since 1985 release

Repair and operation of the car

Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
- Power supply system, carburetor, system of injection of fuel
   Rules of purity during the work with a power supply system
   Removal and installation/check of the sensor in the fuel tank
   Removal and installation of the fuel tank
   Removal and installation of the fuel pump
   Removal and installation/check of the fuel pump
   Removal and installation of the air filter
   - Carburetor
      Adjustment of the carburetor
      Malfunctions in a fuel supply system
      The carburetor with the falling stream and consecutive turning on of cameras
      Check and adjustment of contents WITH
      Check/removal and installation of the valve of interruption in supply of fuel
      Check/removal and installation of automatic equipment of cold start
      Removal and installation of the carburetor
   + System of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits


Each carburetor is checked and adjusted at the plant. In this adjustment nothing can be changed. High fuel consumption and insufficient engine capacity almost always have other reasons among which an important role is played by a manner and traffic conditions. As a rule, it is enough to be limited to careful adjustment of idling and structure WITH. The correct adjustment of idling is much more important, than it is accepted to think as it exerts impact on operation of the engine to average turns.

Carburetor screws by means of which it is possible to change composition of the fulfilled gases on the basis of the law have to be protected by seals. If the carburetor has seals, they can be removed with nippers or the screw-driver. It is expedient to screw in a seal the suitable screw the self-tapping screw and to take out it together with a seal. At the same time they collapse. After adjustment screws have to be protected by new seals.

During the works on the carburetor and a fuel supply system certain rules of purity, see the Head the Power supply system, the carburetor, system of injection of fuel, the Section of the Rule of purity have to be followed during the work with a power supply system.