Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
- Power supply system, carburetor, system of injection of fuel
   Rules of purity during the work with a power supply system
   Removal and installation/check of the sensor in the fuel tank
   Removal and installation of the fuel tank
   Removal and installation of the fuel pump
   Removal and installation/check of the fuel pump
   Removal and installation of the air filter
   + Carburetor
   - System of injection of fuel
      System of injection of fuel
      Memory of malfunctions
      Security measures during the work with system of injection
      Idling check
      Verification of the contents WITH
      Check/adjustment of the sensor of a butterfly valve
      Removal and installation/check of the sensor of temperature of cooling liquid
      Check of gates of injection (injectors)
      Removal and installation of gates of injection
      Check of the fuel pump
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits






Check of gates of injection (injectors)

Gates of injection inject fuel falteringly, i.e. for one turn of the crankshaft a half of fuel absorption, necessary for one step, is injected. At the same time the gate injects fuel in the form of a cone, and after dispersion is densely closed. Faulty gates of injection cause further work of the engine after switching off of ignition and interruptions in operation of the engine.

Work check

 PERFORMANCE ORDER

  1. To leave the engine to idle.
  1. To check each gate on the working engine by means of a stethoscope whether it clicks. These clicks are caused by opening and closing of the gate.
  2. If there is no stethoscope, it is possible to check operation of the gate the screw-driver or a finger.
  3. If noise from work is absent or has unusual character, it is necessary to check shtekerny connection, a signal from the monitor (it is carried out in a workshop) or resistance.

Check of resistance

 PERFORMANCE ORDER

  1. To switch off ignition.
  2. To switch-off plugs of gates of injection.
  3. To measure by an ohmmeter resistance of all gates of injection on sockets.

The required value: (all engines) 12-16 Ohms.

  1. If value does not correspond demanded, the gate of injection should be replaced.
  1. The special tools which are available in the company workshops MAZDA are necessary for check of a stream of injection and tightness of the gate.