Mazda 323

since 1985 release

Repair and operation of the car

Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
- Diesel engine
   Principle of operation of the diesel engine
   Removal and installation of a gear belt / adjustment of the drive of the distributive mechanism
   System of preheat of the diesel engine
   Check of system of preheat
   Removal of air from a power supply system
   Check/replacement of the electromagnetic valve of interruption in supply of fuel
   Adjustment of the drive of gas
   Check/adjustment of speed of idling
   Removal and installation of nozzles
   Removal and installation of the vacuum pump
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits

Removal of air from a power supply system


  1. When opening system or full emptying of the fuel tank it is always necessary to delete air from a power supply system.
  1. To be convinced that in a tank there is a fuel.
  1. To open the gate of removal of air on the fuel filter.
  2. To pump up the manual pump fuel from a tank. The pump is on the top part of the filter.
  3. To pump over until in the fuel which is going out of the pumping gate vials of air do not disappear.
  4. At the pressed manual pump to close the pumping gate.
  5. To pump over the manual pump (about 15 times) until when pressing resistance is felt.
  1. If the engine is not started because of emergence in pipelines of injection of an air stopper, to weaken cap nuts on nozzles and to include a starter that there was a fuel. Then to tighten nuts again and to start the engine.

To watch that diesel fuel did not get on hoses of cooling liquid. If necessary it is necessary to clear hoses at once. The corroded hoses should be replaced.