Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
- Coupling
   Removal and installation/check of coupling
   Removal and installation/check of the release bearing of coupling
   Adjustment of a pedal/cable of coupling
   Check/adjustment of a pedal of coupling
   Removal of air from the coupling drive
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits






Removal and installation/check of the release bearing of coupling

Removal

 PERFORMANCE ORDER

  1. To remove the transmission.
  1. Cars to 9/89 g of the issue and model the versatile person: To disconnect a returnable spring of the lever of switching off of coupling on a case of the transmission and to remove the release bearing from a coupling switching off fork.
  1. Cars from 10/89 g of the issue, except models the versatile person: To remove the release bearing together with a fork of switching off of coupling and then to remove the bearing. On all-wheel drive models from 1/90 g of the issue to consider the adjusting provision of intermediate plates, see an illustration.

Check

 PERFORMANCE ORDER

  1. To squeeze the release bearing and to turn at the same time. On cars from 9/89 g of the issue to stretch the bearing and to turn at the same time. If the bearing rotates hardly, to install the new bearing.

The bearing has long-term lubricant and should not neither be cleared, nor be greased.

Installation

 PERFORMANCE ORDER

  1. To slightly grease prileganiye surfaces on the release bearing and a fork of switching off of coupling with MoS2 lubricant.
  1. To attach the release bearing to a fork and to insert both elements on a transmission shaft.

On all-wheel drive models from 1/90 g of the issue between a fork of switching off of coupling and the release bearing there is a needle bearing which facilitates reduction of coupling in action. Before installation of the new release bearing to rearrange both intermediate plates with a spring from the old bearing on new.

  1. To attach a casing of a fork of switching off of coupling on a transmission case.
  2. If is available, to attach a returnable spring of the lever of switching off of coupling.