Mazda 323

since 1985 release

Repair and operation of the car

Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
- System of ignition
   Security measures during the work with electronic system of ignition
   Check of the coil of ignition
   Check of a cable of ignition
   Check/adjustment of the moment of ignition
   Removal and installation of the distributor of ignition
   Spark plugs
   Candles for MAZDA 323
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits

Security measures during the work with electronic system of ignition

In electronic system of ignition MAZDA 323 tension of ignition can reach 30 kV. Under adverse circumstances, for example humidity in a motive compartment, peaks of tension can punch isolation and at a touch to cause shock. In order to avoid injuries and damages of system of ignition, during the works it is necessary to consider the following:

  • Not to touch by a hand and not to disconnect an ignition cable on the working engine or at a crankshaft provorachivaniye a starter.
  • To disconnect wires of system of ignition only at the switched-off ignition.
  • It is impossible to connect the condenser for suppression of a radio noise to the mass of the coil of ignition or tension indicator.
  • To connect and switch-off measuring devices only at the switched-off ignition.
  • The coil of ignition cannot be replaced with other execution. It is impossible to install the ignition coil intended for system with the breaker at all.
  • When heating more than on 80 °C (for example when painting) the engine cannot be started directly after heating.
  • To make a wash of the engine only on the idle engine.
  • During the works as spot or electric welding the battery should be switched-off in a set.
  • It is forbidden to perform works on system of ignition to persons with an electropacemaker.